The last trellis your climbers will ever need.

This modular honeycomb trellis grows right along with your plant. Start with a Base, clip on Extensions to go taller, or add a Span to connect pieces sideways and build it out wider. Great for pothos, hoyas, string of hearts, philodendrons — anything that likes to climb.

Clean geometric design that actually looks good next to your plants, not just functional.

Stability's tested up to a Base plus two Extensions — go taller than that and give it a bit of extra support (a wall, stake, or another trellis) to lean on.

3D printed from PLA. Like anything 3D printed, you might spot the odd layer line or seam here and there — that's just how it's made, not a fault.

Care: hand wash only, warm water, mild soap. Don't soak it or put it in the dishwasher, and keep it out of direct sun and high heat (above ~80°C) so it doesn't warp or fade.

Indoor decorative use only. Not a toy — not suitable for children under 14.

If we're out of stock when you order, that's not a problem — it just means we print yours fresh, specifically for you, instead of pulling it off a shelf. One of our printers gets loaded up just for your order and it's in the post within 72 hours. You're not getting whatever's been sitting in a box the longest — you're getting one made for you.

Design licensed from NoOrdinaryLeaf, printed and shipped by us right here in Australia.